WD 006-0A90443 PCB

006-0A90443 Hitachi (Western Digital) 3.5" SATA Hard Drive PCB Circuit Board Controller Logic Board

Board Number: 006-0A90443;
Suit for Hitachi (Western Digital) HDD Models: HUS726040AL4214, HUS726060AL5210, HUS7260xxAL421x, HUS7260xxAL521x, HUS7260xxALS21x, etc.

Category: HDD PCB > Western Digital PCB

Western Digital PCB Replacement: Western Digital PCB swap guide

Western Digital PCB 006-0A90443

Western Digital PCB 006-0A90443

The hard drive PCB, also called "hard drive circuit board", "hard drive controller board", "hard drive logic board" or simply "hard drive board (card)" is screwed to the back of the hard disk drive (HDD). HDDZone.com: Donor PCB for data recovery purpose, you can repair your failed hard disk (disc) drive through a change or replacement of PCB boards.

T6/T8 Star Screw Driver
If you don't have the suited screw driver to take off PCB from HDD, you can order one with the PCB. We will deliver the matching screw driver with your PCB.

Before you purchasing please read:

1. These are just PCB (Printed Circuit Boards/Electronics Boards), not the whole HDD (Hard Disk Drive);
2. Most of the PCB are second hand. However, all boards have been fully tested before shipment;
3. All PCB are used as data recovery/repair issues, there is no refund/exchange policy;
4. It is a buyer responsibility to know if the board is adequate for his hard drive model;
5. In most cases, you should exchange the BIOS/Main Controller IC before you swap hard drive PCB, in order to make the replacement board compatible with your HDD.
6. Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your drive to be repaired by replacing the hard drive PCB;