STM3160211AS Seagate PCB Board Hard Drive Logic Controller Circuit Board 100395316 (REV A, REV B, REV C, REV D, REV E are compatible)
Board Number:
100395316 (REV A, REV B, REV C, REV D, REV E are compatible)
Main Controller IC (Smooth Chip): 100404226
HDD Motor Combo IC: SH6960B
Suit for HDD: STM3160211AS Maxtor 160GB SATA 3.5" Hard Drive
Seagate PCB compatibility: Seagate PCB Replacement
Category: Hard Drive PCB - Seagate PCB
Product Images:
STM3160211AS Seagate PCB 100395316
STM3160211AS Seagate PCB 100395316
A hard disk drive (HDD), hard disk, hard drive, or fixed disk, is an electro-mechanical data storage device. The "hard drive pcb" is also called "hard drive logic board", "hard drive controller board", "hard drive circuit board", or simply "hard drive board". This is the (often green) printed circuit board attached to the bottom of your hard drive. You can repair your defective hard disk drive by hard drive pcb replacement.
Please read before purchasing:
- These are just PCB (Printed Circuit Boards/Electronics Boards), not the whole HDD (Hard Disk Drive);
- We only charge shipping fee excluding customs fee. Most customers haven't been charged the Customs fee. If you will be charged the fee, you should be responsible for it.
- Most of the PCB are second hand. However, all boards have been fully tested before shipment;
- All PCB are used as data recovery/repair issues, there is no refund/exchange policy;
- It is a buyer responsibility to know if the board is adequate for his hard drive model;
- In most cases, you should exchange the BIOS/Main Controller IC before you swap hard drive PCB, in order to make the replacement board compatible with your HDD.
- Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your drive to be repaired by replacing the hard drive PCB;
T6/T8 Star Screw Driver
If you don't have the suited screw driver to take off PCB from HDD, you can order one with the PCB. We will deliver the matching screw driver with your PCB.
Seagate PCB Versions
Seagate hard drive PCBs usually have several letter strings after the board number: REV A, REV B, REV C, REV D, REV E, REV F, REV G, etc., which are the version of the board. For users who want to replace the board, different versions can be generic, so we usually ship them randomly! If you would like to specify a version, please leave us a message when placing your order and we will try to make you happy (it usually takes more time to prepare and ship).
